Horizontal Centrifugal Pumps

Technical Features

IMPELLER

The impeller design can be fully adapted to the kind of liquid to be pumped. By means of pressure-leveling holes,

the impeller is axially relieved. The impeller is fixed on the shaft cone, which is a great advantage with diesel

drive. The cone is designed to enable a very easy disengaging of the impeller.

PUMP CASING

The liquid velocities in the pump have been kept very low, which results in minimum wear. The flanges may be

drilled according to DIN or ASA standards. The pressure flange may be fitted in 4 positions with intervals of 90°.

The sealing between pump casing, suction cover and casing cover with stuffing box is obtained by “O”-rings.

PUMP SHAFT

Standard pump design involves a ground stainless steel shaft, protected by a specially treated shaft sleeve, also

made of stainless steel. Pump shaft and bearings are enclosed in a ball bearing cartridge, which enables a very

quick replacement of the shaft and bearings unit. Moreover, this design enables an accurate axial adjustment

of the impeller, which is an advantage with open impellers, equipped with a wearing plate. The front bearing is

protected against the penetration of water by a rotating disk shaped water flinger.